Selection Of The Operating Mode - SORHEA BIRIS II 50 Bedienungsanleitung

SORHEA
Steps
7) Switch 1 and 2 to OFF
Alignment completed
ATTENTION:
In the case in which several products are stacked one above the other, alignment must be
realized column by column with care taken to power off the transmitters that are not in
course of alignment according to the following procedure:
TX column BIRIS II 50
Switch off the column
* To re-enable the transmitters, turn switches 1, 2, 5 and 6 to OFF
6

SELECTION OF THE OPERATING MODE

The BIRIS II 100 and BIRIS II 200 barriers operate in 3 operating modes.
The BIRIS II 50 barrier operate only in mode "AND".
Mode "AND":
-
Simultaneous interruption of 2 cells in dual transmission to trigger the intrusion alarm.
Mode "OR":
-
Interruption of a single cell in dual transmission to trigger the intrusion alarm.
Mode "AND/OR":
-
Simultaneous interruption of 2 cells in dual transmission and/or interruption of the
bottom cell for a minimum of 1.5s to trigger the intrusion alarm.
BIRIS II 50
TX column RX column
ON ON
OFF OFF
1 2 1 2
ALIGN. ALIGN.
- Buzzer OFF
Constant Red LED
green LED off
Column in operation mode "AND"
TX column BIRIS II 100
- 28 -
BIRIS II 100
TX column RX column
ON
OFF
1 2 1 2
ALIGN. ALIGN.
- Buzzer OFF Buzzer OFF Buzzer OFF
Constant Constant green LED, red and
green LED
Heating switch active
TX column BIRIS II 200
Turn switches 1, 2, 5 and 6 to ON *
ON
OFF
1 2
ALIGN.
BIRIS II 50/100/200
BIRIS II 200
TX column RX column
ON ON
OFF OFF
1 2 1 2
ALIGN. ALIGN.
orange off
ON
OFF
5 6
MODE
ON
OFF