Alignment And Adjustment - SORHEA BIRIS II 50 Bedienungsanleitung

SORHEA
ALIGN. CHANNEL
1 2 3
When barriers are stacked (fig. 1) or installed along the same line (fig. 2), select a different channel
for each barrier.
Transmitter
Transmitter
CHANNEL 1
Transmitter
5

ALIGNMENT AND ADJUSTMENT

The alignment is comprised of two phases: the first is comprised of an optical alignment; the second
is comprised of an optimizing phase for the receiver for the models BIRIS II 50 and 100 and for the
receiver and transmitter for the BIRIS II 200.
Optical alignment
Transmitter
This alignment consists of lining up the axis of the transmitter and receiver modules.
This basic alignment adjustment is performed for each module by using the integrated sighting
system and begins with the transmitter modules.
Switch 3 & 4 :
channel selection
ON
RX
4
3 4
ON
OFF
CHANNEL 1
CHANNEL 2
CHANNEL 1
Receiver Receiver
DELAY
3 4 3 4
CHANNEL 2 CHANNEL 3
fig.1
fig. 2
CHANNEL 2
Transmitter Transmitter
Detection zone
- 25 -
BIRIS II 50/100/200
ON
3 4
CHANNEL 4
Receiver
Receiver
CHANNEL 3
Receiver
Receiver