Technical Description - Axion STIM-PRO T-400 Anleitung

AXION

TECHNICAL DESCRIPTION

01
Channel
02 Intensity
EN
03 Pulse amplitude
04
Output Voltage
05 Power Source
06 Size
07 Weight
08 Frequency
09 Pulse width
10 Modes
11 TENS
Burst mode (B)
12
TENS
Normal mode (N)
13 TENS
Modulation
mode (M)
14 SD1 mode (SD1)
15 SD2 mode (SD2)
16 Program mode (P)
17
Low battery
indicator
32
2 channels with adjustable intensity
Adjustabl 0 - 80 mA with a load of 500 Ohm
on each channel
Asymmetrical, bi-phasic square pulse
0 - 50 V
1 pc. 9,0V battery
10,2 cm (L) x 6,2 cm (W) x 3,4 cm (H)
150 g incl. battery
Adjustable from 2 - 150Hz
Adjustable from 50 - 300μs
5 TENS modes with adjustable parameters:
Burst, Normal, Modulation, SD1, SD2.
P-Mode with 12 pre-defined programs (P)
Burst frequency adjustable from 0.5 - 5Hz
Pulse width adjustable from 50 - 300μs
Frequency adjustable from 1 - 150Hz
Pulse width adjustable from 50 - 300μs
The frequency is regulated down to 50%
of the set value within 5 seconds. In the
following 5 seconds the the frequency
increases back to the full value.
The SD1 (Strength-Duration) mode consists of
automatic modulation intensity and pulse width
in 40% range. The intensity is always increasing
while the pulse width is decreasing and vice ver-
sa. The intensity is decreased by 40% while the
pulse width is increased by 40% in 5 seconds. In
the next 5 seconds, the intensity is increased by
40% while the pulse width is decreased by 40%.
Total cycle time is 10 seconds.
As SD1 mode, but with 70% modulation.
Explanation of the programs on p. 26 - 27
A low battery indicator will show up on the
LCD when the battery is low. Replace battery
soon.