Installing A Dimm - ASROCK 775i65G Bedienungsanleitung

2.5 Installation of Memor y Modules (DIMM) 2.5 Installation of Memor 2.5 Installation of Memor
2.5 Installation of Memor 2.5 Installation of Memor
This motherboard provides two 184-pin DDR (Double Data Rate) DIMM slots, and supports
Dual Channel Memory Technology. For dual channel configuration, you always need to
install two identical (the same brand, speed, size and chip-type) memory modules in
the DDR DIMM slots to activate Dual Channel Memory Technology. Otherwise, it will
operate at single channel mode.
If you install only one memory module or two non-identical memory
modules, it is unable to activate the Dual Channel Memory Technology.

Installing a DIMM

Installing a DIMM
Installing a DIMM Installing a DIMM Installing a DIMM
Please make sure to disconnect power supply before adding or
removing DIMMs or the system components.
Step 1. Unlock a DIMM slot by pressing the retaining clips outward.
Step 2. Align a DIMM on the slot such that the notch on the DIMM matches the break
on the slot.
The DIMM only fits in one correct orientation. It will cause permanent
damage to the motherboard and the DIMM if you force the DIMM into the
slot at incorrect orientation.
Step 3. Firmly insert the DIMM into the slot until the retaining clips at both ends fully
snap back in place and the DIMM is properly seated.
ASRock 775i65G Motherboard
y Modules (DIMM) y Modules (DIMM) y Modules (DIMM)
y Modules (DIMM)
notch
break
notch
break
1 3 1 3 1 3 1 3 1 3