How To Run A Wash Cycle Or A Drying Cycle - Indesit EWDE 71680 Bedienungsanleitung

How to run a wash cycle or a
drying cycle
1. SWITCH THE MACHINE ON. Press the
GB
START/PAUSE indicator light will flash slowly in a green
colour.
2. LOAD THE LAUNDRY. Open the porthole door. Load
the laundry, making sure you do not exceed the maximum
load value indicated in the table of programmes on the
following page.
3. MEASURE OUT THE DETERGENT. Pull out the
detergent dispenser drawer and pour the detergent into
the relevant compartments as described in "Detergents
and laundry".
4. CLOSE THE DOOR.
5. SELECT THE WASH CYCLE. Set the WASH CYCLE
knob to the desired programme; a temperature and spin
speed is set for each wash cycle; these may be adjusted.
The duration of the cycle will appear on the display.
6. CUSTOMISE THE WASH CYCLE. Use the relevant
buttons:
Modifying the temperature and/or spin speed. The
machine automatically displays the maximum temperature
and spin speed values set for the selected cycle, or the
most recently-used settings if they are compatible with
the selected cycle. The temperature can be decreased by
pressing the
is reached. The spin speed may be progressively reduced
by pressing the
(the "OFF" setting). If these buttons are pressed again, the
maximum values are restored.
!
Exception: if the 2 programme is selected, the tempe-
rature can be increased up to a value of 60°C.
Setting the drying cycle
The first time the button is pressed, the machine will
automatically select the maximum drying cycle which is
compatible with the selected wash cycle. Subsequent
presses will decrease the drying level and then the drying
time, until the cycle is excluded completely ("OFF").
Drying may be set as follows:
A- Based on the desired laundry dryness level:
Iron dry: suitable for clothes which will need ironing
afterwards. the remaining dampness softens creases,
making them easier to remove; "A1" appears on the display.
Hanger dry: ideal for clothes which do not need to be
dried fully; "A2" appears on the display.
Cupboard dry: suitable for laundry which can be put back in
a cupboard without being ironed; "A3" appears on the display.
Extra dry: suitable for garments which need to be dried
completely, such as sponges and bathrobes; "A4" appears
on the display.
B - Based on a set time period: between 30 and 180 minutes.
If your laundry load to be washed and dried is much
greater than the maximum stated load (see adjacent table),
perform the wash cycle, and when the cycle is complete,
divide the garments into groups and put some of them
back in the drum.
20
button, until the cold wash "OFF" setting
button, until it is completely excluded
At this point, follow the instructions provided for a "Drying
button; the
only" cycle. Repeat this procedure for the remainder of
the load.
N.B: a cooling-down period is always added to the end
of each drying cycle.
Drying only
Use the cycle selector knob to select a drying cycle (15-16)
in accordance with the type of fabric. The desired drying
level or time may also be set using the DRYING button
Modifying the cycle settings.
• Press the button to enable the option; the indicator light
corresponding to the button will switch on.
• Press the button again to disable the option; the
indicator light will switch off.
!
If the selected option is not compatible with the
programmed wash cycle, the indicator light will flash and
the option will not be activated.
!
If the selected option is not compatible with another
option which has been selected previously, the indicator
light corresponding to the first option selected will flash
and only the second option will be activated; the indicator
light corresponding to the enabled option will remain lit.
!
The options may affect the recommended load value
and/or the duration of the cycle.
7. START THE PROGRAMME. Press the START/PAUSE
button. The corresponding indicator light will become
green, remaining lit in a fixed manner, and the door will
be locked (the DOOR LOCKED symbol
To change a wash cycle while it is in progress, pause
the Washer-dryer using the START/PAUSE button
(the START/PAUSE indicator light will flash slowly in an
orange colour); then select the desired cycle and press
the START/PAUSE button again. To open the door while
a cycle is in progress, press the START/PAUSE button;
if the DOOR LOCKED
may be opened (wait approximately 3 minutes). Press the
START/PAUSE button again to restart the wash cycle from
the point at which it was interrupted.
8. THE END OF THE WASH CYCLE. This will be indicated
by the text "End" on the display; when the DOOR LOCKED
symbol switches off the door may be opened (wait
approximately 3 minutes). Open the door, unload the
laundry and switch off the machine.
!
If you wish to cancel a cycle which has already begun, press
and hold the
machine will switch off.
symbol is switched off the door
button. The cycle will be stopped and the
.
will be on).