Edirol AudioCapture UA-1D Bedienungsanleitung Seite 20

Installing and Using the D-Out Smoother
Starting the D-Out Smoother
1
Connect the UA-1D to the USB connector of your
computer.
2
Click the Windows [Start] button, and in the
[Programs] menu, click [D-Out Smoother].
3
The D-Out Smoother will start up.
In some cases it may display "Cannot find USB
Audio Device. Check USB cable or select USB
Audio Device again." when starting. If this occurs,
the computer has not correctly detected the UA-1D. It
is possible that the UA-1D is not connected correctly,
or that the driver has not been installed correctly.
Refer to Installing and Using the D-Out Smoother
(p. 19) and check these points.
Using the D-Out Smoother
The D-Out Smoother has an "ON/OFF" switch and a "TEST"
button.
"ON/OFF" switch
Normally, you will leave this "ON" when using the digital
output of the UA-1D.
Turn this "OFF" when connecting or disconnecting the UA-1D.
"TEST" button
Click the [TEST] button. If the test audio is heard, the D-Out
Smoother is operating for that device.
When using two or more USB Audio Devices such as the
UA-1D or MA-150U, use this button to select the UA-1D for
which the D-Out Smoother will operate.
Use the following procedure to make your selection.
1
From the D-Out Smoother [Control] menu, select
[Setting] to access the Setting dialog box. (This dialog
box will appear automatically the first time the
software is started up.)
20
The Setting dialog box
will appear at the first
time when you start up.
Make sure that the
Wave-Out Device
shows "USB Audio
Device," and click
[OK]. If two or more
USB audio devices are
displayed, refer to
Using the D-Out
Smoother (p. 20), and
specify the correct
device.