Specifications - Gemini mm-04 Bedienungshandbuch

ON/OFF (50) button begins blinking shortly indicating that the
DSP effects are not engaged in CUE MODE. To engage the
DSP, tap the EFX ON/OFF (50) button to engage the DSP EFX.
3. PARAMETER: To adjust the PARAMETER, or dynamics of
the effect signal, use the PARAMETER (52) rotary knob to
expand or minimize the effect level of the DSP effects. Rotate
this knob clockwise to expand the effect. Rotate this knob count-
er clockwise to minimize the effect.
4. LCD: The blue LCD (66) shows the EFX selection abbreviat-
ed name, to indicate which effect is activated or which effect
may be activated at the top part of the screen. While the bottom
part of the screen displays the PARAMETER level as controlled by
the PARAMETER (52) rotary knob.
5. EFX SELECTOR: Use the EFX SELECTOR (51) rotary knob
to scan through the 26 DSP effects as indicated in the blue LCD
(66) display. Once you have found an effect you would like to
engage, press the EFX ON/OFF (50) button to engage the DSP
effect. The EFX SELECTOR (51) rotary knob can rotate 360
while scanning through the effects. Rotate the EFX SELECTOR
(51) rotary knob clockwise to scan forward through the EFX list.
Rotate the EFX SELECTOR (51) rotary knob counterclockwise
to scan backwards through the EFX list. The effects are listed on
page 16.
NOTE: WHEN SCROLLING THROUGH THE EFFECTS YOU WIL FIRST SEE THE NUMBER
OF THE EFFECT, THEN THE LCD (66) WILL AUTOMATICALLY SWITCH THE VIEW TO THE
PARAMETER SETTING. THIS WILL AID IN SCROLLING TO AN EFFECT QUICKLY BY FIND-
ING THE NUMBER OF THE EFFECT.

SPECIFICATIONS:

INPUTS:
Phono:..........................................................3 mV, 47 KOhm
Line:..........................................................150 mV, 27 KOhm
Mic 1, 2, & 3:................................1.5 mV, 1 KOhm Balanced
OUTPUTS:
Amp/Zone:................................................0 dB 1V, 400 Ohm
Max:.........................................................20V Peak-to-Peak
Rec:............................................................225 mV, 5 KOhm
GENERAL:
Frequency Response:........................20Hz - 20KHz +/- 2 dB
Distortion:..................................................................< 0.02%
S/N Ratio:.................................................Better Than 80 dB
Talkover Attenuation:..................................................-16 dB
Headphone Impedance:...........................................16 Ohm
Power Source:..............................115/230V, 50/60Hz, 20W
Unit Dimensions:..................................W 19" x H 3.4" x D 7"
o
...................................................(482.6 x 86.36 x 177.8 mm)
Weight:......................................................8.95 lbs (4.05 kg)
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTIFICATION FOR
IMPROVEMENT.
(6)