Preparing Steam; Frothing Milk - Krups ESPRESSERIA AUTOMATIC PREMIUM Bedienungsanleitung

Steam froths up the milk to make a cappuccino or a caffe latte, for example, and also heats up liquids. As you need a higher
temperature to produce steam than to make an espresso, the appliance runs an additional pre-heating phase for steam.
We recommend that you use pasteurised or UHT milk that has been recently opened. Do not use untreated milk.
After the steam function has been used, the nozzle will be hot, and we recommend that you wait for a few
moments before handling it.
Pour the milk into your
Check that the steam
milk jug. Only half fill it.
nozzle is correctly fit-
Immerse the nozzle in the
ted.
milk.
To remove any remaining
Let the hot water escape
milk from the steam
for at least 10 seconds
nozzle, place a container and then again press the
under the nozzle and
"steam" key
press the "steam" key
water.
To interrupt the steam function, just press any key.
If the nozzle is blocked, clean it out with a fine needle.
The maximum duration for production of steam per cycle is limited to 2 minutes.
SETTING UP THE AUTO-CAPPUCCINO XS 6000 (SOLD SEPARATELY)
This auto-cappuccino accessory makes it easier to make a cappuccino or a caffe latte.
Attach the various parts Select the cappuccino or caffe
together.
latte position on the special nozzle.
The tube must not be twisted to ensure that the button is held in the correct position.
To prevent milk from drying on the auto-cappuccino accessory, it must be cleaned thoroughly after use.. It is recom-
mend that you wash it immediately by carrying out a cycle with steam and the accessory pot filled with water in order
to clean the inside of the nozzle. To do so, you can use liquid cleaner XS4000, available as an accessory.

PREPARING STEAM

While the screen displays the drink selection menu, press the "steam" key
will inform you that the appliance is being pre-heated. Once the pre-heating phase has
been completed, a message will ask you to place a container under the steam nozzle.
Press the "steam" key again to start generating steam. A little water will be produced
first and then steam will start. Use the same key to stop steam generation.
BE CAREFUL, BECAUSE THE CYCLE DOES NOT STOP IMMEDIATELY.

FROTHING MILK

Press the "steam" key
and follow the
instructions on the
screen.
You can remove the steam nozzle for thorough cleaning. Wash it
using a brush with water and a little non-abrasive washing up
liquid. Rinse and dry it. Before re-fitting, make certain that the air
to stop inlet holes are not clogged by milk residues. Clean out the holes
with a needle if necessary.
Fill up the milk pot and place a
cup or a glass underneath the
auto-cappuccino nozzle.
Once your milk is frothy
enough...,
Press the button to start
and then to stop the cycle
7
. A screen
again press the "steam"
key to stop the cycle.
Be careful, because the
cycle does not stop
immediately.
Place your cup under the
coffee outlets and start a
coffee / espresso cycle.