Trouble Shooting - iiyama Vision Master Pro 454 Bedienungsanleitung

TROUBLE SHOOTING

If the monitor fails to operate correctly, please follow the steps below for a possible solution.
1. Perform the adjustments described in OPERATING THE MONITOR, depending on the problem
you have.
2. Consult the following charts if you cannot find an appropriate adjustment item in OPERATING
THE MONITOR or if the problem persists.
3.
If you are experiencing a problem which is not described below or you cannot correct the problem,
discontinue using the monitor and contact your dealer or iiyama service center for further assistance.
Problem
A
The picture does
not appear.
(Power indicator
does not light up.)
(Power indicator
is green.)
(Power indicator
is orange.)
B
The screen is not
synchronized.
C The screen
position is not in
the center.
D
The screen is
too bright or too
dark.
E The screen is
shaking.
14 TROUBLE SHOOTING
o
The Power Cable is firmly seated in the socket.
o
The Power Switch is turned ON.
o
The AC socket is live. Please check with another piece of equipment.
See page 13 for SELF-DIAGNOSIS FUNCTION.
o
If the blank screen saver is in active mode, touch the keyboard or the
mouse.
o
Increase the Contrast and/or Brightness.
o
The computer is ON.
o
The Signal Cable is properly connected.
o
The signal timing of the computer is within the specification of the
monitor.
See page 13 for SELF-DIAGNOSIS FUNCTION.
o
If the monitor is in power management mode, touch the keyboard or the
mouse.
o
The computer is ON.
o
The Signal Cable is properly connected.
o
The signal timing of the computer is within the specification of the
monitor.
o
The Signal Cable is properly connected.
o
The signal timing of the computer is within the specification of the
monitor.
o
The video output level of the computer is within the specification of the
monitor.
o
The signal timing of the computer is within the specification of the
monitor.
o
The video output level of the computer is within the specification of the
monitor.
The screen may be too bright due to the video output level difference of
the computer. In this case, adjust the Contrast.
o
Check if there are any sources of strong magnetic fields such as TV,
speakers, etc. nearby.
If yes, remove them from the area of the monitor or change the position/
direction of the monitor to avoid magnetic field interference.
o
The power voltage is within the specification of the monitor.
o
The signal timing of the computer is within the specification of the
monitor.
o
Moiré correction is working properly.
Check