Velleman VMM502 Bedienungsanleitung Seite 17

The block show string
can be found in the
Since there are only two conditions, we need only one
pressed, the green LED will light up. Else, if no force is applied to the crash sensor, the red LED will
blink continuously.
 When complete, we compile the programme to generate a .hex file. Click on the download button and
save the .hex file to the
micro:bit.
 Plug the micro:bit into the USB port via the micro-USB cable. Then, drag and drop the .hex-file (from
the Downloads
8.4 Project 4 – Plant Monitoring Device
Set up a plant monitor!
1 micro-USB cable
2 micro:bit
3 passive buzzer
4 BoB
What do I need?
 1x micro:bit
 1x micro-USB cable
 1x BoB
 1x passive buzzer
 1x moisture sensor
 1x OLED
 2x female-female jumper wires
V. 01 – 17/01/2019
can be found in the
Advanced Pins in the Code Drawer.

Downloads folder (C:\downloads). This .hex file is ready to be uploaded to the
folder) onto the micro:bit
VMM502
OLED in Code Drawer. The
else if statement. When the crash sensor is
Removable device to upload the programme.
5 OLED
6 mini servo (not used)
7 soil moisture sensor
17
digital write pin P0 to 0
©Velleman nv
block