Cleaning Instructions - Williams Sound Pocketalker 2.0 Benutzerhandbuch

Cleaning Instructions

CAUTION!
Avoid getting any liquid inside the Pocketalker unit as it can
damage the circuit board and will void the warranty.
1. Use an alcohol wipe or 3% hydrogen peroxide solution to
clean the outside of the Pocketalker case and the earphone/
headphone cord. Wiping cloth should be damp rather than
soaking wet (see Caution #5). Lightly swab the unit down, as
pressing hard may release liquid into the unit (see Caution #5).
2. The Pocketalker can be carefully cleaned with "Hospital
Cleaner Disinfectant Towels with Bleach, or alcohol" however, we
cannot guarantee that the coloring / markings on the unit will not
be affected as a result of multiple bleach applications.
3. Replace the earphone foam pads with each new user, or use
disposable sanitary headphone covers with each new user.
(Earphone/headphone pads/covers are available through
Williams Sound).
4. If using a plug-in microphone (MIC 014-R), replace the optional
disposable sanitary microphone cover (WND 012) with each new user.
(Both the MIC 014-R Plug-In Microphone and WND 012 Sanitary
Microphone Cover are available through Williams Sound. The
WND 012 is sold in packs of 100).
5. Do not spray or put liquid directly on the unit. Apply cleaning
solution to a wipe or swab to clean the Pocketalker. Avoid
pressing hard. It is crucial that "No Liquid" of any kind gets in the
electronics of the unit, (i.e. Headphone jack, microphone jack,
USB charging jack, internal speaker, internal microphone, volume
knob, tone control or t-coil switch).
22