Using An Optional Neckloop; Using The Lanyard - Williams Sound Pocketalker 2.0 Benutzerhandbuch

Using an Optional Neckloop

Williams Sound's optional neckloop (NKL 001) can be used with the
Pocketalker in situations where the user has a hearing aid with a
T-coil.
WARNING!
should not be used if there is a risk of getting it lodged or stuck in
machinery or other objects.
How it works: The Pocketalker picks up the sound with the
internal or external microphone, and sends it into the neckloop.
The neckloop magnetically couples with the T-coil in the listener's
hearing aid(s). With the hearing aid T-coil switch on, the listener
can hear the sound directly in their hearing aid(s).
To use the neckloop: Place the neckloop around your neck as
shown below. While holding the housing with one hand, pull up
on the cord lock bead with the other hand to tighten for comfort.
Plug the neckloop into the headphone jack on the Pocketalker.
Turn on the T-coil in the hearing aid(s). Turn on the Pocketalker
and adjust the volume to a comfortable listening level.
Using a Neckloop
Note:
The RCS 003 Lanyard has a safety
breakaway feature that disconnects
18
when too much pressure is applied
To prevent strangulation, the neckloop
The NKL 001 neckloop has a safety breakaway feature
that disconnects when too much tension is applied to
the neckloop.
Cord Lock "Bead" Pull up to tighten
Neckloop "Housing" Hold down while tightening