sauermann Si-82 Anleitung Seite 8

EN
The SI1800, Si-82 or SI-1801centrifugal monobloc pumps are designed for use with all kinds of Air conditio-
ning units, refrigeration display cabinets, fan coil units and gas condensing boilers. They can also be used
with gas fired furnaces. The pump can be used to remove acid condensates (pH > 2.5) and condensates
with a temperature of up to 65°C.
Technical specification : SI82CE01UN23 - SI82CE02UN23
- SI1800SCUN23 - SI1802CUN23 - SI1802SCAN23
Mains supply
EN
Safety switch
Max. flow rate
Max. discharge head
Operating time
Noise level in application
Water levels (mm)
Max. condensate tempera-
ture & acidity
Tank volume
Thermal protection
(overheat)
Protection
Actual flow rates (l/h)
The head losses defined in this table are calculated with
a Ø 10 mm int. hose.
Vertical Total tubing length
discharge
5 m
head
1 m 380
2 m 310
3 m 240
4 m 150
5 m 30
WARNING
- This pump has been designed for use with water only.
- This pump has been designed for indoor use only. It must not
be immersed and/or placed in areas of high humidity or where
the ambient temperature conditions are below freezing.
- The appliance is not to be used by children or persons with
reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given
supervision or instruction.
- Children should be properly supervised to ensure they do not play with the appliance.
- In case of breakdown, in particular if the supply cord is damaged, it must be replaced by a Sauermann
service agent or a similarly qualified person in order to avoid any hazard.
- For models fitted with a supply cord without a plug, a means for disconnection must be incorporated to the
fixed wiring in accordance with local wiring rules.
WARNING:
Risk of electric shock. This pump is supplied with a grounding cable and a grounding
attachment plug. To reduce the risk of electric shock, ensure that the pump is connected only to a suitable
grounding device.
8
N921-04_1505.indd 8
230V~ 50Hz - 70 W - 0.67 A
NC 4 A resistive - 250V
500 l/h
5.0 m
S3: 30% (3 s ON – 7s OFF)
45 dBA at 1 m (3.3 ft)
Fig. 4
t<65°C (80°C - 1min),
pH>2.5
2.0 l
105°C (auto-reset)
IP 20
10 m 20 m 30 m
300 240 190
260 200 150
200 145 110
130 80 60
20 0 0
Technical specification : 17' : SI1801LHUS11
23' : SI1801SCUS11 - SI1801SCUS23
(1)
SI1801US23/T
(4)
Mains supply 120V~60Hz
230V~50/60Hz
Safety switch
Max. flow rate
Max. discharge 60Hz
head 50Hz
Operating time
Noise level in application
Water levels (mm)
Max. condensate
temperature & acidity
Tank volume
Thermal protection
(overheat)
Protection
Actual flow rates (gph)
The head losses defined in this table are calculated with
a Ø 1/4'' (10 mm) int. hose.
17'
Vertical Total tubing length @ 60 Hz
discharge
16 ft
head
(5 m)
3 1/4ft (1 m) 92
6 1/2ft (2 m) 79
10ft (3 m) 61
13ft (4 m) 40
16ft (4.9 m) 13
23'
Total tubing length @ 50 / 60 Hz
Vertical
discharge
16 ft
head
(5 m)
3 1/4ft (1 m) 100
6 1/2ft (2 m) 82
10ft (3 m) 65
13ft (4 m) 50
16ft (4.9 m) 30 /37
18ft (5.5 m)
(5)
- SI1801US11/T
-
(2) (3)
17' 23'
56W - 1.05 A 85W - 1.45 A
(5) (1) (3)
80 W - 0.72 A
(2) (4)
NC 4 A resistive - 42 V peak
132 gph (500 l/h)
16' (4.9m) 21' (6.4m)
18' (5.5m)
S3: 30% (3 s ON – 7s OFF)
45 dBA at 3.3 ft (1 m)
Fig. 4
t<150°F - 65°C, 1 min
pH>2.5
1/2 US Gal (2.0 l)
230 F° (110°C) 248°F (120°C)
auto-reset auto-reset
IP 20
30ft 60ft 100ft
(10 m) (20 m) (30 m)
82 63 53
69 53 44
52 40 33
32 26 21
30ft 60ft 100ft
(10 m) (20 m) (30 m)
92 74 61
75 61 50
58 48 38
42 36 28
26 /29 21 /22 16 /17
11 /20 8 /13 5 /11
26/01/2015 14:11:04