Toro 51452 Bedienungsanleitung Seite 6

Replacing Line
For replacement line, purchase a new, pre-wound spool of line
(model no. 88175) or bulk line (0.065 inch dia. (1.6 mm) x 30ft.
(9 m)) that you can wind onto the old spool. Both are available
from your Authorized Toro Dealer.
Metal wire, rope, plastic knives, or any material other than
Toro .065 inch dia. (1.6 mm) nylon monofilament may
overload the motor, possibly causing a fire or electrical
shock.
Do not use any material other than Toro .065 inch dia.
(1.6 mm) nylon monofilament, 30 ft. (9 m) maximum line
length.
Removing the Spool
1. Twist the cap off counterclockwise (Figure 12).
Figure 12
2. Remove the cap and spool (Figure 13).
Note: If the spring falls off, install it before installing the
spool.
Figure 13
3. Thoroughly clean the cutting head and cap and inspect them
for any damaged or worn parts.
Rewinding the Spool
Note: If you are replacing the spool with a new, pre-wound
spool, discard the empty spool and skip this section.
1. Remove any cutting line left on the spool.
2. Hook one end of line all the way into the slot on the spool
(Figure 14), allowing no more than 1/8 inch (3 mm) to
protrude.
Figure 14
3. Wind the line in the direction of the arrow on the spool, in
level rows, between the spool flanges.
Important: The trimmer will not function correctly if
you wind the line in the wrong direction, the end of the
line protrudes more than 1/8 inch (3 mm), or you wind
more than 30 ft (9 m) of line on the spool.
Installing the Spool
If you do not fully install the spool and cap, the trimmer
could throw them during operation, causing injury to you
or bystanders.
1. Holding the line and spool, insert the spool into the cutting
head and the line into the eyelet (Figure 15).
Figure 15
2. Holding the line and spool, place the cap over the spool
(Figure 16).
Figure 16
3. Twist the cap on securely clockwise (Figure 17).
Figure 17
6