Philips Vapor Forte 60 Gebrauchsanweisung Seite 5

- Select the required ironing temperature with
the temperature dial (fig. 5).
- After a few minutes, pilot light (C) will go out.
This indicates that the soleplate has reached
the set temperature.
• While the soleplate is heating up, condensation
(drops of water) may occur. Just let the
soleplate heat up a little longer.
- While steam-ironing keep the steam activator
(A) pressed-in (fig. 6).
It may take a few seconds before steam is
emitted from the soleplate.
• If the room temperature is higher than approx.
20 °C (68 °F), the steam will be almost
invisible.
Do not hold your hand close below the
soleplate to check the steam production.
Table
Tabel with Kind of
ironing fabric
instructions
Synthetic
e.g. acetatet,
acryllic,
viscose,
B
polyamide,
polyester
Silk
C
Wool
Cotton
D
Linen
Please note:
Z
This article cannot be ironed!
Temperature Steam
dial ironing
MIN
A
A
1
A
A
A
A
2
A
A
3
MAX
Steaming in a vertical position
Hanging curtains and clothing (jackets, woman's
suits, coats) can be steamed by holding the iron
in a vertical position (fig. 7).
Dry-ironing
• For ironing without steam, do not press-in the
steam activator (fig. 8).
If you wish to dry-iron only, there need not be
any water in the water tank.
If this is the case do not press switch "On/Off"
I , but only press switch "Ironing" ≥
Guarantee and service
For guarantee conditions and further information:
see the folder with your steam cleaner.
5
–