General Installation And Starting Tips; Installation - cattani ASPI-JET series Gebrauchsanweisung

• General installation and starting tips

• Installation


Aspi-Jet 7 is fi tted with automatic drainage, it must be con nect ed to the waste of the building.
Besides the general features of Aspi-Jet 7
func tion: water supply to the tumbler and spittoon (cuspidor) with rinsing re spec tive ly. The
switches which con trol the above functions are marked with symbols and are located on the front
panel:
- a tumbler indicates the water supply on type 8
- a tap indicates rinsing of the spittoon on type 9
• General installation and starting tips
• Unpack the appliance following the instructions shown on the package.
• Dispose of the package in compliance with regulations.
• Verify that the appliance has not been damaged during transport.
• Do not connect damaged appliances to the mains.
• Do not use extension leads, multiple plugs or sockets.
• Ascertain that the feeding line is adequate to feed the machine.
• Assembly of the aspirator must be carried out by an expert, with suitable equipment and special
training. The installer should read the equipment manual, perform commissioning and instruct
the users in the use and routine maintenance of the new machine while it is still unused and
therefore not contaminated.
• The air exhausted by the aspiration system should be fi ltered, with a special certifi ed antibacterial
fi lter available on request, and expelled to the outside.
• After installation, perform the required safety and operating tests.
• Arrange for periodical inspection of the equipment. This will not only prevent stoppage of a chair
or of the whole surgery, but is also a way to prevent injuries and accidents.
• You can fi nd all our updated manuals at our website: www.cattani.it. We recommend that you
consult them, especially for updates on the subject of safety.
• Installation
The aspirator must be installed in compliance with CEI 62-5
regulation for electro-medical appliances (Aspi-Jet 6-7-

8-9 have been designed accordingly).
Prior to plugging in the unit, check the specifi cations on the
label and make sure that the mains are com pat i ble with the
appliance and pro tect ed against overcurrent according to
CEI 64/8 reg u la tions.
The appliance must be protected against indirect contacts
for class appliances according to CEI 64-8 reg. and 64-4
for rooms used as medical consulting rooms (IEC cor-
respondents available on demands).
The plug and cable are equipped with earthing pro tec tion:
do not remove this protection in any case and make sure
that the socket is com pat i ble.
18
 
Aspi-Jet 8 and Aspi-Jet 9

;

.

offer some ad di tion al
3C 2
Fig. A