Philips HR 3610 Gebrauchsanweisung Seite 6

come on.
- To stop Timer function, press the button again
and the pilot light goes out.
- You can change the timer setting during
operation.
- As time elapses, the remaining time will light
up.
Off
- Press "OFF" to switch off the fan.
All function settings will be canceled including
timer.
Control panel type HR 3615
(1)
(2)
1 Remote control receptor
2 Speed selection and on/off button
You can operate the fan either by the remote
control unit or by the OFF/ON•SPEED button
on the control panel.
Speed selection
- Press the "OFF/ON•SPEED" button once to
switch on the fan at high speed.
Pilot light "3" will come on.
- Press the "OFF/ON•SPEED" button twice to
switch on the fan at medium speed.
Pilot light "2" will come on.
- Press the "OFF/ON•SPEED" button three times
to switch on the fan at low speed.
Pilot light "1" will come on.
Natural Wind
- Press the "OFF/ON•SPEED" button
four times for "Natural Wind".
Pilot light "l" will blink.
The fan will change speed at a random pattern,
producing comfortable natural wind.
• Press the "OFF/ON•SPEED" button once more
for switching off the fan.
All function settings will be canceled, including
timer.
• The timer can only be set by means of the
Remote Control Unit (U).
Remote Control Unit type HR 3615
(1)
(2)
1 Infra red transmitter
2 Speed selection button
3 Timer setting button
4 Off button
• The buttons of the remote control unit (U) have
the same symbols and functions as the
corresponding buttons on the control panel of
type HR 3610.
Please refer to section "Control panel type
HR 3610" on page 5.
• Please direct the Infra Red Transmitter towards
the Remote Control Receptor on the control
panel while pressing the buttons.
Ensure that there is no obstruction between
transmitter and the receptor (fig 6).
The maximum effective distance between the
transmitter and the remote control receptor is
3 m.
• You can also operate the remote control unit
(U) when it is put inside the control panel as
illustrated in fig. 7.
Storage
The fan can be disassembled for compact
storage:
- For the fan grilles (B, H) and fan blade (E),
reverse the assembly procedures on page 4.
- For the detachable fan base (S), first untighten
the two screws (T) on the bottom of the fan
base with a screw driver.
Then press the four clips in the direction as
illustrated in fig. 9 and pull the fan stand (0) out
carefully.
6
(3)
(4)