Maestro MR081 Bedienungsanleitung Seite 7

mode automatically. The red light is to go off.
Boiling water is over.
ATTENTION! During boiling the thermos pot lid
must be closed.
Note: after a while color of the surface of the
heating element can vary slightly. This is a normal
phenomenon caused by exposure to chemicals in the
4
Picture
water and heating, it is not a malfunction.
After the boiling indicator goes out and the "Keep
warm" indicator lights up, you can start bottling the
water in one of three ways:
1. Bring the cup to the spout unit and press the button
located on the flood water spout by the edge of the
cup Picture 7a.
5 2. Press and hold the "Water supply" located not on
Picture
the device control panel. As long as the button is
pressed, the built in electric pump is to pump water
through the spout Picture 7b.
3. Press the button of mechanical pump on the lid of
the thermos pot Picture 7c.
Automatic heating temperature (keep warm) below the
boiling temperature.
If necessary, you can quickly bring the water to a boil.
6
To do this, click the "Re-boiling" button.
Picture
а
Water dispense
Re-boiling
b
7
EN
c
7
Picture