Troubleshooting - Sony WRT-847A Bedienungsanleitung

Troubleshooting

If you have any problem using the transmitter, use the following checklist. Should any problem persist, consult your Sony
dealer.
Symptom
The transmitter does not turn on.
The batteries run down quickly.
The transmitter cannot be turned off.
The channel cannot be changed.
There is no sound.
14
(GB)
Meaning/Remedy
The + and – poles of the batteries do not match those of the battery compartment.
ˎ
batteries with the poles correctly matched.
 Replace the batteries with new ones.
The batteries are exhausted.
ˎ
The battery terminals in the transmitter are dirty.
ˎ
 Replace the batteries with new ones.
The batteries are exhausted.
ˎ
A manganese batteries are being used.
ˎ
battery is less than half that of an alkaline battery.
The transmitter is being used under cold conditions.
ˎ
conditions.
The HOLD switch is in the HOLD position.  Move the HOLD switch to the left so that the green line
appears.
An attempt was made to change the channel by pressing the SET button only.  Turn the transmitter
off, then turn it on again while holding down the SET button. Then change the channel with the +
and – buttons.
The indication on the LCD is flashing.
ˎ
off, then on again.
The channel setting on the transmitter is different from that on the tuner.
ˎ
setting for both the transmitter and tuner.
The AF or RF indicator does not turn on.
ˎ
on.
 Clean the + and – terminals with a cotton swab.
 Use the alkaline batteries. The battery life of a manganese
 The batteries run down quickly under cold
 The transmitter is in channel setting mode. Turn the power
 Confirm that the transmitter and tuner are both turned
 Insert the
 Use the same channel