Setting The Menu; Inputting Image From Main To Sub - Computer Signal - Christie LW41 Bedienungsanleitung

5.4 Setting the menu

If Intellectual Stack with RS-232C connection is used, observe the followings.
When inputting image signals to Sub via Main, the operations differ between using
computer signals and video signals such as component and video signals.

Inputting image from Main to Sub - Computer signal

1.
If the STACK menu is already displayed on the screen, proceed to 3 below.
Otherwise press the MENU button on the remote control.
If the MENU dialog is displayed, use the ▲/▼ buttons to
highlight MAIN, and press the ► button. A menu will be
displayed.
If the MENU dialog is
2.
Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION > STACK
STACK menu will appear on screen.
(Operating Guide
3.
Use the ▲/▼ buttons to highlight SUB INPUT
SOURCE, and press the ► button to display the
SUB INPUT SOURCE dialog.
4.
Use the ▲/▼
button to complete the setting. ( 23 )
5.
Press the COMPUTER or VIDEO button on the
remote control or the INPUT button on the con-
trol panel of the Main projector, the MAIN INPUT
SOURCE dialog is displayed on screen. Use the
▲/▼ buttons to highlight the port to which the sig-
nal cable is connected, and
complete the setting.
NOTE • When FIXED (COMPUTER IN 1) is selected, the MONITOR OUT
setting is invalid.
• When FIXED (COMPUTER IN 1) is selected, input sources other than
COMPUTER IN1 and COMPUTER IN2 cannot be selected.
• When FIXED (COMPUTER IN 1) is selected, if any button for setting the
input ports including COMPUTER, VIDEO, MY SOURCE/DOC.CAMERA and
MY BUTTON (assigned with input source related functions) buttons on the
remote control and the INPUT
selecting the input source will be displayed.
LX41/LW41 User Manual - Instant Stack Guide
not displayed, the STACK menu will appear.
→ OPTION
buttons to highlight FIXED (COMPUTER IN 1), and
press the ► button to
(Operating Guide
button on the projector is pressed, the dialog for
Setting input ports using menu
menu)
SETUP menu)
→
31
press the ►
020-000509-01 Rev.1 (06-2012)