Indicators And Functions; Operation Instructions; Install And Replace Batteries; Auto Operation - CLIVET CFK 007.0 Installations- Und Bedienungansleitung

INDICATORS AND FUNCTIONS

Temp
1
Transmitting display
2
Running mode
4
AUTO
TEMP
COOL
SET
DRY
CLOCK
HEAT SET
FAN
FAN SPEED
Economic operation
8
Temp: Display the set temperature. Adjust temperature via
and . No display in this area if the unit is on FAN mode.
Transmitting display: The icon will flash once when the signal
is sent by remote controller.
ON/FF: Icon is displayed when the remote controller is turned
on, or vice versa.
Running mode: Press MODE to display current running mode.
AUTO, COOL, DRY, HEAT and FAN can be selected. (HEAT
function is invalid for cool only type unit.)
Time: Display the current set time. Press CLOCK for 5s, icon
indicating hour will flash. Press this button again, icon indicating
minute will flash. And are used to adjust the figure. Setting
or modification is effective only by pressing OK button to make
confirmation.
Lock: The icon will be lightened or off when pressing LOCK.
In locked state, all the buttons are ineffective except button
LOCK.
Time ON/OFF: In the state of time ON, icon ON will be
lightened, which is the same to the state of time OFF.
Setting timer ON and OFF simultaneously, both icons ON
and OFF are displayed.
INDICATORS AND FUNCTIONS
ON/OFF
3
Time
5
Lock
6
Time ON/OFF
HOUR 7
ON OFF
Fan speed
9
Chart 2
Fan speed: Press FAN SPEED to display the current wind
speed. AUTO, LOW, MED and HIGH can be selected. The
default state is high fan speed for the unit without medium
fan speed.
Economic operation: This icon will be lightened or off when
pressing ECO button.
NOTE: All the above icons will be displayed only when
the remote controller is electrified for the first
time or reset.

OPERATION INSTRUCTIONS

Install and replace batteries

Install 2 pieces of 7# alkaline batteries.
Slide the cover to install batteries and make sure to
place them in right pole.

AUTO operation

Switch on the power and running indicator light on indoor unit
flashes.
1. Press MODE to select AUTO.
2. Adjust temp via and . Generally the range is 17 ~30 .
3. Press ON/OFF and running indicator light on indoor unit is
lightened. Air conditioner will work on AUTO mode and fan
speed is AUTO which is nonadjustable.
4. ECO is effective on AUTO operation.

COOL/HEAT/FAN operation

1. Press MODE to select COOL, HEAT or FAN.
2. Adjust temp via and
3. Press FAN SPEED to select AUTO, LOW, MED or HIGH.
4. Press ON/OFF and running indicator light on indoor unit is
lightened. Air conditioner will work on the set mode. Stop
operation via ON/OFF.
5
. Generally the range is 17 ~30 .
OPERATION INSTRUCTIONS
6