Safety Precautions - Mitsubishi Electric VL-50S2-E Sicherheitshinweise Für Die Installation

CAUTION
• Please be sure to read this safety caution and the files on the CD-ROM before proceeding with the installa-
tion. Failure to follow the instructions may result in equipment damage.
• If the files are not readable, please contact your dealer.
For information not contained in this booklet, please refer to the CD-ROM that is supplied with the unit.
1. Safety precautions
Hazards created by mishandling and their severity
are indicated by the following markers.
Warning:
This applies to mishandling or misoperation of the
product which could lead to a fatal or serious injury.
Caution:
This applies to mishandling or misoperation of the
product which will lead to an injury or damage to
your home, household effects, etc.
Warning
- Do not install the unit in excessively
hot areas (40°C or more), near open
Prohibited
flames, in areas prone to oily smoke,
or where it could come in contact with
organic solvents.
- Fire could result.
- Do not disassemble the unit more than
necessary or modify it.
Do NOT
- Fire, electric shock or injury could result.
disassemble.
- Do not let the unit get wet.
- Fire or electric shock could result.
Do not expose
to water
- Do not install the unit and wall switch
in a bathroom or other highly humid
Cannot be
location.
installed in a
bathroom - Electric shock or short circuits could
result.
- Use at the rated voltage.
- Fire or electric shock could result.
You must
follow the - Make sure the outside air intake
instructions
opening is positioned so that it will
given.
not take in combustion gases or other
exhaust. Position the unit so that it will
not become covered with snow.
- If intake air is not fresh, oxygen could
become depleted in the room.
- Install the unit securely to a sufficiently
strong wall surface.
- Injuries could result if the unit falls.
- Connect wires securely to terminal
block connections so they do not come
1
out.*
- Poor connections could result in fire.
- Electrical work must be done by
an electrical contractor (a licensed
electrician) in accordance with the
technical standards of the equipment
and local regulations to ensure safety.
1
- Bad wiring and mistakes in electrical
work could result in electric shocks or
fire.
- Install an all-pole power supply
isolator at the power supply side as
per local electrical regulations. All
supply circuits must be disconnected
before obtaining access to the terminal
devices. Use the specified cable size
and connect the cables securely to
prevent disconnection when they are
pulled.
- If there is a defect in the connection,
there is a possibility of fire.
- Be sure to shut off circuit breakers or
remove the power plug from the wall
outlet if the Lossnay will not be used
for a long period after installation.
- Failure to do so could result in electric
shock from deteriorated insulation, or fire
from a short circuit.
- Always place a cover on the terminal
block after construction work is
complete.*
- Dust, humidity and the like could cause
short circuits or fire.
Caution
- Install the unit only on a wall. Do not
install it on a ceiling.
Prohibited
- Injury could result if the unit falls.
- Wear gloves when attaching the unit.
- Failure to wear gloves could result in
You must
injury.
follow the
instructions
- Attach the air supply/exhaust pipe in
given.
a downward slope toward the outdoor
side and make sure to apply thermal
insulation treatment.
- Rainwater entering the unit could result
in electric shock, fire or indoor items
getting wet.
- Make sure to perform drain discharge
in accordance with the Installation
Manual.
- Failure to heed this warning could cause
electric shock/fire or water damage to
household property due to water leaks.
- Install the provided weather covers.
- Rainwater entering the unit could result
in electric shock, fire or indoor items
getting wet.
1