Elmo QBiC X1 Gerätehandbuch Seite 32

●When severe contamination is found, first check if the USB connector port and card
slot are properly covered, rinse with fresh water, and wipe with a dry soft cloth.
■Luminescent spot and black spot
●This product uses a CMOS area image sensor composed of numerous pixels, and
some of the pixels may not operate normally. Therefore, luminescent spots or black
spots could be witnessed on the output screen. This is not a defect but a phenomenon
peculiar to the CMOS area image sensor.
■Image data
●This product is composed of precision electronic parts and components. If this product
is handled as follows, the internal data of microSD card could be destroyed:
- WiFi card and micro SD card are dislodged, or power is turned OFF while this
product is in operation.
-The USB cable (included in the package) comes out during communication.
●Under those circumstances, ELMO shall not be liable for any damages due to
corruption of or loss of the recorded data.
■WiFi card and microSD CARD
●When using microSD card other than supplied, format it with this product before
starting to use.Do not use any other device to format.Some microSD card may not be
capable of use even after formatting with this product. The result varies with
manufacturer and type.
●Do not remove WiFi card while the device is accessing micro SD card (recording). It
may cause malfunction or breakdown.
●After use or for storage or transportation, put WiFi card and microSD card into a case
or pouch.
■Performance and lifetime of built-in battery
●A rechargeable lithium ion battery is used in this product.
●The battery has its own life span. Along with the frequency of use, time of use and the
time passed, battery capacity decreases gradually.
●If operation time becomes substantially short at normal temperature (10°-30°Celsius
or 50°-86°Fahrenheit is ideal), the battery life seems to have come near its end.
Replace it with a new battery.Contact your dealer or ELMO Customer Service for
battery replacement (fee applies).
32