Connecting Through Infrastructure Communication -Check Before You Connect; Connecting Through Infrastructure Communication -Configuration Of The Product - Elmo QBiC X1 Gerätehandbuch

* Communication distance is dependent on the environment. In case of communication trouble,
shorten the distance between the product and the Monitor, or retry at other location where there
are no obstacles.
CONNECTING THROUGH INFRASTRUCTURE COMMUNICATION
–CHECK BEFORE YOU CONNECT
Check 1A "Wireless LAN access point" needs to be set up in advance to connect
through infrastructure communication. Prepare the instruction manual of the
"Wireless LAN access point" such as a router beside you and follow the below
steps.
Check 2The explanation in this guide is based on the assumption that the devices
which have wireless LAN access points, such as a router, support "DHCP server
function".
For the procedure of connecting to the devices which do not support "DHCP
server function", refer to the QBiC instruction manual.
CONNECTING THROUGH INFRASTRUCTURE COMMUNICATION
–CONFIGURATION OF THE PRODUCT
The following description shows how to configure the product. Prepare a computer with
the QBiC Setup Tool installed and the supplied USB cable.
Check [SSID] and [KEY(encryption key)] of the wireless LAN access point in advance.
1. Open the micro USB Port Cover of the product.
2. Connect the micro USB plug (smaller one)of the supplied USB cable to themicro
USB port of the product.Connect the USB plug of the USB cable to a USB port on
your computer.
3. Power on the product.
4. Boot the"QBiC Setup Tool" installed on your computer.
5. Click [Network] icon in the tool.
6. Click [Infrastructure] tab.
7. Put a tick mark to [Connect through Infrastructure Communication at
start-up].
8. Click [AP Search Setting].
9. A list of wireless LAN access point near your computer appears.
18