Mass Storage Mode; Turning On The Mass Storage Mode - Elmo QBiC X1 Gerätehandbuch

11. If "Communication Error" message is displayed on the application, check the
settings for the product and the Monitor. Then reboot the application after rebooting
the product and the monitor.

MASS STORAGE MODE

This product can be used asa storage device. Using this mode, you can retrieve the data
stored in the micro SD card.

TURNING ON THE MASS STORAGE MODE

1. Power off the product. Open the micro USB Port Cover of the product.
2. Connect the micro USB plug (smaller one)of the supplied USB cable to themicro
USB port of the product.Connect the USB plug of the USB cable to a USB port on
your computer.
3. Press and hold (over 5 seconds) [Power Switch].
4. The micro SD card inside the product is recognized as a removal disk.Three beep
sounds occur and the menu appears on the screen of your computer.
5. Select the menu and operate.
6. Power off the product. Remove the USB cable from the product and attach the
micro USB Port Cover.
* Make sure you attach the cover properly and completely. Insufficient attachment may
deteriorate the waterproof performance and damage the product.
Connect first and then power on.
20