Operation - Maestro MR010 Bedienungsanleitung

person responsible for their safety.
- Children should be supervised to ensure that they do not play with
the appliance.
ATTENTION!
- The surface of the device becomes very hot during operation.
Be careful because you may burn yourself greatly by touching the
surfaces of the cover, case, water of vapor.
- Do not open the cover of the kettle during boiling.
- Do not lift the kettle by its cover.
- Take and lift the kettle only keeping it for the handle, touch only the
buttons of the device.
- Do not fill the kettle with the water level higher than the mark
«MAX».
- Place the kettle only on a dry, stable, even, slip-resistant surface.
- Lift the kettle full with hot water with special care!
In case of failure to observe the above mentioned rules there
arises the danger of burning!
- To avoid possible damages by vapor turn the kettle nose away
from walls and furniture when it is boiling. Use the support to save
the sensitive cover of furniture from damages.
- Do not place the kettle on heating devices.
- Do not close the opening for the exit of vapor near the switch.
- Do not use the kettle without a cover.
- Do not switch the kettle on without water or when the water level is
below the mark «MIN». If the kettle is empty or there is not enough
water in it, it is automatically turned off by safety device. In such case,
disconnect the device from the mains, let it cool down and then fill it
with water again and turn it on; the kettle will begin to boil water and
after the end of this process it will turn off in the regular regime.
6
Purchase industrial devices for commercial use.
Actions in extreme situations:
- If a device tumbled into water, immediately, unplug the device, not
touching to the device or water.
- In case of appearance from appliance of smoke, sparkling, strong
smell of a burn isolation, immediately stop use the device, unplug
the device, appeal to the nearest service center.

Operation

Before the first use:
- Remove packing and advertising materials and stickers.
- Inspect the kettle and make sure that there are no damages to the
kettle, power line cord, plug.
- Unwind the power line cord completely.
CAUTION! Is required on surfaces where heat may cause a
problem – an insulated heat pad is recommended.
- Open the cover.
- Fill the kettle with cold water up to the mark «MAX». Close the
cover (until it clicks).
- Connect the plug to the mains.
- Press the button «I». The indicator will light signaling that the
device has turned on, and the kettle shall begin warming the water.
- After boiling, the kettle switches off automatically. (After about 5
min, please switch the switch button to «О», to make the steam
switch recover, and then can continue boiling).
You must pour out the first portion of water and repeat the boiling
procedure again.
- Now the kettle is ready for use.
ATTENTION! Do not fill the kettle with cold water until cools down;
let it get cool before filling with cold water.
EN
7