Joining The Boundary Wire; Software Update - Worx Landroid Bedienungsanleitung

®
Whilst observing Landroid locating the charging station you can then make alterations to the boundary wire route to ensure
trouble free tracking of the boundary wire by Landroid

7.3 Joining the boundary wire

Use a connector if the boundary wire needs to be extended and spliced. It is waterproof and ensures a reliable electrical
connection.
Insert both wire ends in any two of the three holes of the connector. Ensure that the wires are fully inserted into the
connector so that both ends are visible through the transparent area on the other side of the connector. (See Fig. I1)
Use a gripper to completely press down the button on top of the connector. (See Fig. I2, I3)
WARNING! It is not recommended to simply splice the boundary wire with insulating tape or use a screw terminal
block for connection. Soil moisture may oxidize the wire and result in a broken circuit after a time.
I1
8.

Software update

The software can be updated when new versions become available.
The latest software can be downloaded from our website www.
worxlandroid.com. There are two methods to update software.
Method 1: Update via USB. See below for download and
installation instructions:
Step 1: Locate the latest software version at: www.worxlandroid.
com. Copy the " .pck" or "bin" file containing the latest software
version to a USB memory stick.
NOTE: Before transferring the " .pck" or "bin" file make sure the
memory stick does not contain other files or data.
Step 2: Turn the Main switch (8) to "O"(off) to turn off your
®
Landroid . Remove the USB lid and Insert the USB memory stick (See
Fig. J).
Step 3: Turn the main switch (8) to "I"(on) to turn on the Landroid
The new software version will be updated automatically. Meanwhile,
the battery indication light will be green flashing and the error
indication light will be blue flashing until the software updates
successfully. If the software update is OK, you can also hear a sound
of "ding-ding-ding" .
Step 4: Remove the memory stick and fit the USB lid.
Method 2: Update via your smartphone. (Only for specific model,
please check Technical Data & Declaration of Conformity)
®
If your Landroid is connected to you smartphone, you can check the
software version on you smartphone. Also, it will notify you when
new software version is available.
The manual in box is based on the default software in the mass
production. Some new features/functions in the new version may not
exist in the manual. If you found some settings not in the manual,
please visit www.worxlandroid.com to download the latest manual.
Lawn Mowing Robot
®
when locating the charging station.
I2
I3
®
.
J
13
EN