Total Dose Time Co; Reset Log - TechGrow T-2 Pro Handbuch

Delay time 0m
=> Dose time Off
>> NEXT >>
Delay time 30m
=> Dose time 11h00
>> NEXT >>
Press the PTK to confirm.
Example
Lights will be on from 11:00 to 23:00 and the
"Delay time" is set to 30m.
30 minutes after the light cell has detected light,
the T-2 Pro will regulate the CO
The "Dose time" is set at 11 hours. The CO
controlled from 11:30 to (+ 11) 22:30.
When this function is enabled, the screen displays the
following:
TMP = 29.8 °C
RH = 63 %
CO2 = 848 PPM
Dawn 00:14:24
The bottom line of your controller will alternately
display the following information:
BOX 100% Auto
•
Dawn 00:14:24
•
CO2 cntr 00:00:00
•
An hourglass appears at the end of the line indicating
that the controller is decelerating (mode dawn).
If the delay time has elapsed, this line (mode dawn) will
change into "Day time":
BOX 100% Auto
•
Day time 10:59:24
•
CO2 cntr 00:26:15
•
An asterisk appears at the end of the line indicating that
the controller is regulating.
If the dose time has elapsed, the line will change into
"Dusk" until the lights go off (based on the example,
this is from 22:30 to 23:00):
BOX 100% Auto
•
Dusk
•
CO2 cntr 01:56:15
•
A square appears at the end of the line.
____________________________________________________________________________________________________________________________
TechGrow | Innovative Growing Solutions
level in the room.
2
will be
2
NOTE: You can also set dose delay/dose time from the
boot menu, "CO2 setup", "Delay / dose".

11.7 Total dose time CO

The T-2 Pro also keeps track of the total dosing time. To
read the cumulative dosing time, select >> NEXT >> in
the next screen:
Delay time 0m
Dose time Off
=> >> NEXT >>
Press the PTK:
Total CO2 1h08
Reset total

Reset log

>> NEXT >>
On the first line you see the total (cumulative) time
during which CO is dosed.
2
11.8 Reset log
Total CO2 1h08
=> Reset total
Reset log
>> NEXT >>
To reset the total dosing time, select "Reset total" and
press the PTK.
Total CO2 1h08
Reset total
=> Reset log
>> NEXT >>
Select "Reset log" and press the PTK to reset the daily
dosing times (7 days) from the "Dose log".
Select >> NEXT >> and press the PTK to proceed with
CO min/max.
2
2
31