Temperature Settings; Day/Night Settings Temp; Hysteresis Temp; Day/Night Delay Temp - TechGrow T-2 Pro Handbuch

After a few seconds, the boot menu is displayed:
System settings
CO2 setup
BOX selection
>> HOME <<
You can read more about this menu further
on in the manual.
After a few seconds the main screen is displayed:
TMP = 29.8 °C
RH = 63 %
CO2 = 848 PPM
CO2 cntr 00:00:00
In the main screen you can see all relevant data at a
glance.
TMP = 34.8 °C
RH = 43 %
CO2 = 848 PPM
CO2 cntr 00:00:00
If a value is too high or too low (relative to Temp set,
RH set, CO alarm day time/CO
2
marked by an arrow behind that specific value.
The bottom line "CO2 cntr" (the total amount of CO
dosed that particular day) is alternated with the line
"BOX" and the line dose delay with "Dusk", "Dawn" or
"Day time" (see sections 11.6, 11.7 and 16.3).

9. Temperature settings

You are in the main screen. Press the PTK and select
"TMP".
=> TMP = 29.8 °C
RH = 63 %
CO2 = 848 PPM
CO2 cntr 00:00:00
Press the PTK to enter the next screen:
____________________________________________________________________________________________________________________________
TechGrow | Innovative Growing Solutions
set overnight), it will be
2
2
Temp day 28.0 °C
Temp night 28.0 °C
Temp +/-
>> NEXT >>

9.1 Day/night settings Temp

To set the desired day temperature, select "Temp day",
press the PTK and set the desired value.
Press the PTK to confirm.
=> Temp day 30.0 °C
Temp night 28.0 °C
Temp +/-
>> NEXT >>
To set the desired night temperature select "Temp
night", press the PTK and set the desired value.
Press the PTK to confirm.
Temp day 30.0 °C
=> Temp night 28.0 °C
Temp +/-
>> NEXT >>

9.2 Hysteresis Temp

To adjust the hysteresis (+/- 1 – 5 °C) select "Temp +/-":
Temp day 30.0 °C
Temp night 28.0 °C
=> Temp +/-
>> NEXT >>
Press the PTK and adjust the value by turning the PTK.
Press the PTK to confirm.
Select >> NEXT >> and press the PTK to proceed with
setting "D&N delay".

9.3 Day/night delay Temp

=> D&N delay 5m
>> NEXT >>
27