Panasonic KX-NS8290 Sicherheitsanweisungen Seite 3

– The Trunk Adaptor is exposed to rain, water, or any other liquid.
– The Trunk Adaptor is dropped or damaged.
– Internal components are exposed due to damage.
– The Trunk Adaptor does not operate properly.
– Performance deteriorates.
• Disconnect the Trunk Adaptor from the AC outlet and disconnect the LAN cable if
the Trunk Adaptor emits smoke, an abnormal smell, or makes unusual noise.
These conditions can cause fire or electric shock. Confirm that smoke has stopped
and contact an authorised service centre.
• Clean the AC plug periodically with a soft, dry cloth to remove dust and other
debris.
• If using an AC adaptor, use only the optional AC adaptor KX-A239AL
(PQLV206AL), KX-A239BX (PQLV206CE), KX-A239CE (PQLV206CE),
KX-A239EJ (PQLV206E), KX-A239UK (PQLV206E), KX-A239X (PQLV206), or
KX-A420BR (PSLP1662). Since the AC adaptors that can be used vary depending
on the country/area, contact an authorised service centre for details.
• If damage to the Trunk Adaptor exposes any internal parts, immediately disconnect
the cable or cord. If the power is supplied from the network to the Trunk Adaptor
(Power-over-Ethernet), disconnect the Ethernet cables. Otherwise, disconnect the
AC adaptor cord. Then return the Trunk Adaptor to a service centre.
• The Trunk Adaptor should only be connected to a power supply of the type shown
on the label on the Trunk Adaptor.
• Completely insert the AC adaptor/power plug into the AC outlet. Failure to do so
may cause electric shock and/or excessive heat resulting in a fire.
• When installing or testing a Trunk Adaptor with an external AC adaptor, the AC
adaptor should be plugged into a wall outlet or floor-mounted AC outlet. Do not
connect the AC adaptor to a ceiling-mounted AC outlet, as the weight of the
adaptor may cause it to become disconnected.
• The DC jack cover poses a choking hazard. Keep the DC jack cover out of reach
of children.
• When the Trunk Adaptor is no longer in use, make sure to detach it from the wall.
• Do not install the system in the following locations:
– In direct sunlight and hot, cold, or humid places. (Temperature range: 0 °C to
40 °C)
– Areas where sulphuric gases may be present, such as near thermal springs.
– Near devices that generate high frequencies, such as sewing machines or
electric welders.
CAUTION
3