Panasonic KX-NS8290 Sicherheitsanweisungen Seite 2

– Areas with high amounts of dust. High amounts of dust can lead to fire or
electric shock, and impair the performance of the product.
• Do not connect or disconnect the AC plug with wet hands.
• Do not touch the Trunk Adaptor, AC adaptor or AC adaptor cord during a lightning
storm.
• Do not allow anything to rest on the AC adaptor cord or LAN cable. Do not locate
the Trunk Adaptor where the AC adaptor cord or LAN cable may be stepped on or
tripped on.
• When installing the Trunk Adaptor with an external AC adaptor, the AC adaptor
should be plugged into a wall outlet or floor-mounted AC outlet. Do not connect the
AC adaptor to a ceiling-mounted AC outlet, as the weight of the adaptor may cause
it to become disconnected.
• Make sure that you do not short the cables.
• Never attempt to insert wires, pins, etc. into the vents or other holes of the Trunk
Adaptor.
• Do not splash water on the AC adaptor or the AC adaptor cord, nor get them wet.
Doing so can result in fire, electric shock, or injury. If they do get wet, immediately
disconnect the AC adaptor, and contact an authorised service centre.
• Do not touch the AC adaptor for extended periods of time. Doing so can lead to
low-degree burns.
• Do not make power connections that exceed the ratings for the AC outlet or power
equipment. If the power rating is exceeded, it can cause a fire due to heat buildup.
• Care should be taken so that objects do not fall onto, and liquids are not spilled into,
the Trunk Adaptor. Do not subject the Trunk Adaptor to excessive smoke, dust,
moisture, mechanical vibration, shock, or direct sunlight.
• Do not place heavy objects on top of the Trunk Adaptor.
• Do not mount the Trunk Adaptor in a manner other than that described in the
Installation Manual.
• The Trunk Adaptor must only be installed and serviced by qualified service
personnel. The Trunk Adaptor should be used as-is from the time of purchase; it
should not be disassembled or modified. Disassembly or modification can cause a
fire, electric shock, or damage to the Trunk Adaptor.
• Make sure that the wall that the Trunk Adaptor will be attached to is strong enough
to support the Trunk Adaptor (approx. 500 g). If not, it is necessary for the wall to
be reinforced.
• Only use the wall-mounting equipment (screws, washers) included with the Trunk
Adaptor.
• Be careful not to drop any components. Dropping components may damage them
or cause an injury.
• Disconnect the Trunk Adaptor from the AC outlet, disconnect the LAN cable, and
contact the dealer if:
– The AC adaptor cord or AC plug becomes damaged or frayed.
2