User Manual - Marmitek POWERMID XL Gebrauchsanleitung

USER MANUAL POWERMID XL
SAFETY WARNINGS
• To prevent short circuits, this product should only be used inside and only in dry spaces.
Do not expose the components to rain or moisture. Do not use the product close to a
bath, swimming pool etc.
• Do not expose the components of your systems to extremely high temperatures or
bright light sources.
• Do not open the product: the device contains live parts. The product should only be
repaired or serviced by a qualified repairman.
• In case of improper usage or if you have opened, altered and repaired the product
yourself, all guarantees expire. Marmitek does not accept responsibility in the case of
improper usage of the product or when the product is used for purposes other than
specified. Marmitek does not accept responsibility for additional damage other than
covered by the legal product responsibility.
• Adapters: Never connect an adapter or power cord when it is damaged. In that case,
contact your supplier.

USER MANUAL

1. Plug the POWERMID XL™ RF Transmitter into a 220V/240V outlet in the room where
you want to use your remote control (up to 20 feet/6 meters away from where you want
to control your A/V equipment). Make sure the front of the RF Transmitter (with POWER-
MID name) faces you. Fully extend the antenna.
2. Plug the POWERMID XL™ RF Receiver into a 220V/240V outlet in the room where your
DVD, Decoder, VCR, Stereo, etc. is located (max. 20 feet/6 meters distance). Make sure the
front of the RF Receiver (with POWERMID name) faces the DVD, Decoder, VCR, stereo etc.
Fully extend the antenna.
3. Point your remote control at the POWERMID XL™ RF Transmitter. The RF Transmitter
receives the infrared signals, converts them to RF signals and transmits them to the POWER-
MID XL™ RF receiver. The RF receiver then converts these signals into infrared again and
transmits these to your DVD, Decoder, VCR, stereo, etc.
Add more Transmitters (Art.no. 08902) when you want to control your A/V equipment
from different rooms.
Add more Receivers (Art.no. 08903) to control equipment in different rooms.
Add an Infrared Extender (Art.no. 09682) if you need to place the POWERMID XL Receiver next
to your equipment instead of in front of it, or if your equipment is located inside a closed cabinet.
TM
POWERMID XL 3