Owner's Manual; Read This First - Marmitek GIGAVIDEO 40 Betriebsanleitung

manual_giga40 12-04-2002 11:06
MARMITEK GIGAVIDEO 40

OWNER'S MANUAL

READ THIS FIRST!

Caution: to reduce risk of electric shock, do not disassemble any part of the videosender system.
No user-serviceable parts are inside. If you spill liquid on it, disconnect the unit from the AC outlet
to prevent possible fire or shock hazard and consult authorized service personnel.
Use only the supplied powersupplies. Defective parts must be replaced by original spareparts only.
Powerline operated equipment or accessories connected to the unit should bear the CE
certification mark and should not be modified in any way that might defeat the safety features.
Warning: to prevent electric shock hazard, do not expose any part of the video Sender to rain or
moisture. Do not use near a bath tub, swimmingpool, etc. Disconnect the unit during
thunderstorms from mains and other connected equipment to avoid damage.
No guarantee or liability will be accepted for any damage caused due to incorrect use of the
equipment supplied, other than indicated in this owner's manual.
APPLICATIONS:
The Marmitek GIGAVIDEO 40 is designed to transmit audio and video signals, without running wires
There is a second radio transmission system providing a infra-red return path enabling you to
control your VCR or Satellite Receiver from a remote location.
• Watch a movie on any TV in Your home without moving your VCR or running cables
• Watch satellite programs on any TV anywhere in your house
• Watch DVD movies from your PC on your TV in a remote location
• Listen to MP3 audio from your PC on your Hifi system in the livingroom
• Monitor your sleeping baby, eldery or disabled on your TV by using your videocamera or
CCD camera
• Make perfect demonstrations without wiring TV's during trade-shows, seminars, etc.
1. SETTING UP THE MARMITEK
GIGAVIDEO TRANSMITTER:
1. Connect one set of Audio/Video cables to the VIDEO [C] and AUDIO [D] jacks of your
Marmitek GigaVideo Transmitter. Take care to match the colors of the plugs on the cable
with the jacks on the GigaVideo Transmitter.
2. Connect the other end of the cable to the Audio/Video OUT jacks of the video source you want
to transmit the signal from (e.g. your VCR, DVD, Satellite or TV). If your video source is
equipped with a SCART connector use the SCART Adapter labelled TRANSMITTER.
GIGAVIDEO 40
Page 3
3