Safety Precautions - Fender Passport PD150 Plus Bedienungsanleitung

Safety precautIoNS

The Fender Passport sound system is supplied
with a detachable power cable with an IEC female
connector and a male AC connector. Depending
on the territory in which the Passport system is
purchased, the power cable will be supplied with one of a
number of male AC connectors to accommodate the different
safety and code requirements of specific countries. All AC cables
supplied with Passport products are three pin grounded types.
Under no circumstances should the ground (earth) pin be
disconnected or removed.
Your Passport System features a Switch-Mode-Power-Supply
designed to operate on any AC voltage and line frequency
to convert AC power with maximum efficiency. When using
plug adapters or operating in a territory other than the
one in which the unit was purchased, take great care to
comply with local safety requirements and electrical codes
of practice.
If you are not sure of the local voltage, wiring codes
& colors, AC grounding, or correct procedures for
connection, consult a qualified technician .
Warning
Under no circumstances should the ground
pin on the Passport or on any of your electrical
equipment be lifted. It is possible that under certain
circumstances a combination of different types of
ungrounded equipment can create a life threatening shock
hazard. Microphones have metal cases and are connected
through the mic cable to the mixer's chassis. Your Passport
mixer may be correctly grounded if the building's wiring is to
code and the ground pin on the AC plug is properly connected.
However if for any reason external AC powered equipment
with ungrounded AC connections are used in conjunction
with the Passport system (e.g. an ungrounded music amplifier),
there may be a difference in potential to the microphone
case. With this combination a performer holding a (grounded)
microphone coming into contact with an ungrounded item of
powered equipment may be subject to dangerous electrical
shocks.
By following the correct procedures and safety precautions,
risks of severe shock hazard can be minimized. Always check
the AC connection and particularly the voltage between the
microphone and any other AC equipment. Avoid operating
the system in conjunction with ungrounded or improperly
grounded electrical equipment.
traNSportatIoN latcheS
To open and close your Passport system, simply follow these
guidelines:
1. Place your finger tip under the
safety latch {A} and gently lift. When
the safety latch has disengaged, lift
both latches {A & B} clear on each
speaker before attempting to remove
the speaker.
2. To replace, position each speaker on
the tower foot and bring the speaker
in to close the engagement with the
tower and latches. Position the latch
hooks over the speaker notch and
close the latches. The 4 latches will
automatically engage.
Note: These parts are precision
engineered and no force is needed
to secure them. Careful alignment of
parts will ensure easy operation.