Stereo Inputs - Fender Passport PD150 Plus Bedienungsanleitung

Stereo INputS

result in the input source only appearing at one of the outputs.
When the switch is in the stereo position, the full stereo field
is heard.
B. STEREo (RCA) INPUT – The Stereo phono (RCA) input
jacks are designed for use with a tape player, CD player, MP3
player, DAT player, or any other stereo source. Use these jacks
for connecting the output of a computer sound card or other
similar device to your Passport. Adapters that convert an 1/8"
male plug to RCA male phono plugs are readily available at
electronics stores. Note: These connectors are set at a constant
"line level".
C. STEREo – This stereo (1/4") input jack is wired for Tip=Left,
Ring=Right and Sleeve=Ground, the standard format of
commercially available cables. The sensitivity of this input is
suited for playback devices such as CDs, Cassettes, DAT or Mini
Disc. Outputs from instruments such as keyboards can also be
used here (refer to item O).
D. STEREo oUT – The Stereo Out RCA jacks provide an output
mix that is independent of the Master Level Controls. Connect
these to the inputs of a recording device, such as a cassette or
DAT recorder, to record your event. Changes made during the
performance, to the input level controls, channel EQ, and reverb
controls will be heard in the Stereo Out mix, while changes
made to the master level controls will not affect the level of the
recording. Adjust recording levels according to the instructions
on your recording device.
A. STEREo/ MoNo SWITCH
– This switch allows you to
select between a stereo or
mono input from either the
RCA or 1/4" stereo input jacks.
This switch should be set to
the Mono position when a
source such as a guitar is input
to this channel, thus allowing
the mono source to be applied
to both outputs at the same
level. Failure to do this will
aux aNd footSwItch jackS
into the Passport's signal flow. This 1/4" output jack is designed
to feed the Passport's effects bus signal to an external signal
processing device, such as a digital delay or a chorus.
B. AUX/RET ST – Plug the output of your external effects
signal processor in here. This 1/4" input stereo jack is designed
to accept signals from an external processing device, such as a
digital delay or a chorus unit. This input can also be used as a
stereo input with the volume controlled at the master volume
knobs.
C. FooT SWITCH – The footswitch connector allows the
internal reverb return to be muted, or shut off, through the
use of a simple foot operated switch (Fender part number
099-4052-000). The footswitch should be wired to connect the
tip to the sleeve to turn the reverb off, and requires a standard
speaker or instrument cable.
11
A. REv/AUX SEND – Plug your
external effects signal processor
in here. Although the Passport is
already equipped with on-board
digital reverb, an external effects
signal processor can be incorporated