Disposal; Fehlerbehebung - Zipper Maschinen ZI-MD500HS Betriebsanleitung

16.10

Disposal

Do not dispose the machine, machine components fuel and oil in residual waste. Contact
your local authorities for information regarding the available disposal options. When you buy
at your local dealer for a replacement unit, the latter is obliged to exchange your old.
17

FEHLERBEHEBUNG

Trouble
Engine will not start
Engine starts and is stalled
immediately
Machine works with interruptions
Machine does not work with full
performance
End of the chain is blocked
Machine does not run while the
engine is running
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-MD500HS
Possible cause
 Incorrect starting sequence
 Dirty air filter
 No fuel supply
 Fault in the fuel line
 Engine flooded.
 Spark plug connector not placed
on.
 No ignition spark
 Incorrect idle adjustment
 Carburetor incorrectly adjusted
 Spark plug fouled
 Machine overloaded
 Dirty air filter
 Carburetor incorrectly adjusted
 Foreign material between the
chains and Chassis
 Gear is not engaged properly
N O T I C E
FEHLERBEHEBUNG
Trouble
 Observe the correct starting
sequence
 Clean/replace air filter
 Refuel
 Check the fuel line for kinks
or damages
 Screw off, clean and dry the
spark plug. Then pull the
cranking rope several times
and reinstall the spark plug
 Place on the spark plug
connector
 Clean/replace spark plug
 Check ignition cable
 Contact customer service
 Contact customer service
 Clean/replace spark plug
 Check spark plug connector
 Too much pressure
 soil too tough
 Clean/replace air filter
 Contact customer service
 Remove foreign body
 Shift lever in right position
switch
39