Operation; Operation Instructions; Functions Of Components; Start Up - Zipper Maschinen ZI-MD500HS Betriebsanleitung

15

OPERATION

Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, controls and screwed connection for damage and
if tightened properly. Replace any damaged parts before operating the device.

15.1 Operation instructions












15.2 Functions of components

Engine switch: The engine switch must be in the ON position for the engine to run.
Turning the engine switch to the OFF position stops the engine.
Throttle control: Controls engine speed. Put the throttle control on low speed(L)or high speed(H)
Right steering lever: Operate the lever to turn right
Clutch control lever: Squeeze the lever, clutch engaged. Release the lever, clutch disengaged
Left steering lever: Operate the lever to turn left
Gear selection lever: Controls forward (6x) or reverse (2x) movements of the machine.
Tipping handle: Controls the tipping of the dump box hydraulic!)

15.3 Start up

15.3.1 Fill in engine oil

ATTENTION! For transport engine oil has been drained. Fill up with 4-
stroke quality motor oil before first operation! Failure to do so will result
in permanent engine damage and void guarantee!
 Use engine oil (SF 15W40)
 Remove oil cap (1)
 Fill in engine oil (Engine oil tank capacity 0,95l:
do not overfill!)
 Tighten the oil cap
 Wipe any oil residues
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-MD500HS
Disengage clutch lever before starting the engine
Always hold the unit with both hands when operating.
Do not rapidly accelerate, turn sharply or stop.
Do not overload the machine capacity
Always make certain that the weight is evenly balanced
Always move in directions parallel with the slope (up or down).
Change the gears only when the machine stands still!
To avoid danger, do not shift gears on slopes
Attention: While tipping the centre of gravity will change suddenly!
Do not tipping on soft ground
H I N W E I S
W A R N I N G
OPERATION
33