Operation; Start Engine; Idle Speed; Stop The Engine - Zipper Maschinen ZI-MD500HS Betriebsanleitung

15.4 Operation

15.4.1 Start Engine

Start the engine, if you have your wheeled dumper mounted correctly:
 Set the gear selection lever (7) to the neutral position.
 Move the choke lever on the machine to the full choke position.
 Turn engine switch to "ON".
 Pull the starter rope several times so that the carburettor is filled with gasoline.
 Pull the starter handle, pull-out until resistance is felt. Let the rope rewind slowly across and
then move expeditiously.
 Run the pull-starter handle slowly to the rope guide back as soon as the engine starts.
 Set the choke lever after a few seconds of engine run position ˝OPEN˝
To start the engine is warm the choke lever is not to be operated.
 When the engine is warmed up, place the gear lever (7) (forward / reverse) in the desired
position. If the desired gear can not load, press the clutch lever short and repeat the
process. After inserting the gear lever Push the clutch lever and the mini transporter begins
to drive. Drag to adjust the throttle lever to the speed accordingly.
 With the steering arm on the handles and can be easily controlled. To drive in the desired
direction each use the right or left steering lever.

15.4.2 Idle speed

Throttle lever to the "SLOW" (SLOWLY) take to protect the motor if no work is done.
Downshifting the engine to idle prolongs the life of engine reduces fuel consumption and the noise
level of the machine.

15.4.3 Stop the engine

To stop the engine, release the clutch lever and turn the switch on the motor to the "OFF" position.
Under normal conditions, proceed as follows.
a. Move the throttle lever to the SLOW position.
b. Allow engine to idle for 1-2 minutes.
c. Turn engine switch to OFF "OFF".
d. Turn the fuel valve lever to OFF.
ATTENTION: Not move the choke lever to stop the engine to CHOKE. Risk of reignition or
damage to the engine!
NOTES
The steering characteristics change proportional to the speed driven and the laden weight. The

lightly loaded machine can be steered with lighter lever operation. With greater loading of the
steering lever to control with higher pressure.
The highest loadings of mini handling is according to the floor on which the machine is used to

adjust.
It is therefore recommended to drive on difficult tracks in a low gear and with caution. In such

situations, the machine to be driven over the entire range in a low gear.
Avoid sharp turns and frequent changes of direction when driving on the road, especially on

rough, tough terrain, which has many sharp, uneven areas, causing high friction.
Although the unit has 4-wheel traction, please remember, to be careful when working under

adverse weather conditions (ice, rain and snow) or on soils where the mini-dumper could be
unstable.
When the clutch lever is released, the machine is automatically braked and stops.

If the machine is stopped on steep slopes, one of the wheels must be secured with a wedge.

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-MD500HS
OPERATION
35