Before First Use; Unpacking; Power Supply; Battery Operation - Telefunken Rd1002 Bedienungsanleitung

3.

BEFORE FIRST USE

3.1

Unpacking

Remove all packaging.
„
Check for the presence of all parts and for transport damage.
„
In case of damage or incomplete delivery, please contact
your dealer (
Please keep the packaging. The appliance can be stored in it
„
if it is not used for a longer period of time.
Place the appliance on a level, stable, clean and dry surface.
„
Ensure that there is sufficient ventilation. Keep a minimum
„
distance of 5 cm between the product and other objects or
walls.
3.2

Power supply

The appliance can either be powered through a wall outlet or with batteries.
„
Insert the power adaptor (14) into the
„
power plug to a suitable wall outlet. Make sure that the power supply voltage is the same as
needed for the appliance.
3.3

Battery operation

Open the battery compartment (16) at the back of the appliance.
„
Insert 4 batteries (1.5 V
„
markings on the backside of the appliance.
Use batteries of high quality only. Batteries of low quality might leak and cause damage. Do not
„
use new and old batteries together. Close the battery compartment lid after inserting the batteries.
Important: Do not use the appliance with a wall outlet and batteries at the same time. Remove
„
batteries before connecting the appliance to mains power and remove the power plug (14) if the
appliance is to be powered by batteries.
The appliance is ready for operation.
„
Note: The appliance draws a small amount of power even if it is not turned on. If you do not use
„
the appliance for a longer period of time, disconnect the power plug (14) or remove all batteries.
4.

BASIC FUNCTIONS

4.1

Switching the appliance on and standby

Press the
„
Press the
„
To completely switch off the appliance, disconnect the power plug (14) from the wall outlet or
remove the batteries. Do this if you do not use the appliance for a longer period of time.
4.2

Setting volume level

Set the volume by turning the VOLUME control (5).
„
4.3

Setting the clock

In standby mode, press the ALARM / SNOONZE button, the hour digits will flash in the display,
„
rotate the SCROLL control to set the correct hour, then press the SELECT button to confirm.
The minute digits will now flash, rotate the SCROLL control to set the correct minute and
„
confirm with SELECT.
Later you will enter to "Set date 1-1-2017", the day digits will flash in the display, rotate
„
SCROLL control to set the correct day, then press the SELECT button to confirm.
the
The month digits will flash in the display, rotate the SCROLL control to set the correct month,
„
then press the SELECT button to confirm.
The year digits will flash in the display, rotate the SCROLL control to set the correct year, then
„
press the SELECT button to confirm.
Warranty).
, type AA / LR06 / R06) (not supplied) according to the polarity
On / standby button (4) to switch on the appliance.
On / standby button (4) again to switch the appliance to standby.
inlet (18) at the back of the appliance. Connect the
16