Cleaning And Maintenance - Velleman VTSS230 Bedienungsanleitung

Wait until the cooling process has stopped, then disconnect the power plug. The device
uses a small amount of electrical power, even if it is switched off.
7. How to Solder
7.1 Precautions
To extend the life of the heating element in the hot air gun, do not use the device
continuously at a low airflow and a high temperature. Allow the heating element to cool
after maximum 20 minutes of usage. Place the hot air gun back in its stand when not in
use.
Make sure that both heater and nozzle are cold before attaching the nozzle.
High temperatures! Both nozzle and airflow are extremely hot and can cause severe
burns. Never touch the nozzle and heater assembly or allow the hot air to blow against
your skin. When used for the first time, the hot air gun may emit some white smoke,
but this will soon dissipate.
Always let the unit cool down after use. After switching off, leave the power cord
plugged in for a few minutes. When you switch off the unit, the automatic cooling
function blows cooling air through the heater pipe for a short period. This protects the
heater from damage and extends its lifetime. Do not disconnect the mains plug during
this cooling process.
7.2 Setup
Do not force the nozzle or pull its edges with pliers.
1. Make sure the appliance is switched off and the iron/air gun is completely cooled
down.
2. Select the air nozzle and slide it onto the air gun.
3. Plug in the power cord and switch on the station.
4. Select the temperature and airflow.
5. Wait until the temperature is stable.
8.

Cleaning and Maintenance

8.1 General
Only perform the maintenance as described in this user manual. Contact an authorised
dealer or service agent for any other maintenance or repair.
If the iron or station becomes faulty or, for some reason does not operate normally,
return it to the service department of your authorized dealer or service agent.
Clean the outer cover of the iron and station with a damp cloth and a small amount of
liquid detergent. Never submerge the unit in liquid or allow any liquid to enter the case
of the station. Never use any solvent to clean the case.
Use only original replacement parts.
V. 02 – 20/08/2018
VTSS230
6 ©Velleman nv