Vari Lite VL3500 Luminaire series Handbuch Seite 67

Display Definition
Index1 Gobo Index
Inv Pan Invert Pan
Inv Tilt Invert Tilt
Lamp Lamp
Lamp OFF Lamp is Off
Lamp ON Lamp is On
LampHour Lamp Hours
Lum Id Luminaire ID
Magenta Magenta
Manual Manual
Movement Movement
OFF
OK
OK? Okay?
ON On Indefinitely
Pan
Pan/Tilt Pan/Tilt
PASS Test Pass
Power Lamp Power
Power Up Power Up
Program Programming
Re-Cal Recalibrate
ResetDef Reset Defaults
ResetLmp Reset Lamp
RotGobo Gobo Wheel 1
Rot Shut Rotating Shutter
RUN TEST Run Test
Sensor Sensors
Setup Setup
Status Status/Error
Strobe Strobe
STST Sensor Test
Swap Swap
Test
Tilt
Version Version
Zoom Zoom Function
02.9 678.00 19 0
Table 4-2: Menu Function Definitions (Continued)
Purpose
Specifies rotating the gobo index for manual control (Manual) and testing (Test)
(EOT sensor, etc.)
Reverses pan action for special focus requirements.
Reverses tilt action for special focus requirements.
Accesses lamp power-up options, reset and information (Config) or presets the
Zoom and Edge to a specific setting for Lamp adjustment (Test).
Configures arc luminaire so that lamp will not strike upon power up.
Configures arc luminaire so that lamp will strike upon power up.
Displays total number of lamp operating hours.
Displays unique luminaire ID number.
Specifies magenta parameter for manual control (Manual) or testing (Test).
Accesses options for luminaire mechanism control by entry of data values.
Enables or disables pan and tilt movement.
Off Turns off a function.
Okay Indicates calibration has completed and no errors have occurred.
Prompt for pressing [Enter] before an action is executed.
Sets Menu Display to stay on until programmed otherwise (Display) or turns on a
function.
Pan Specifies pan function for manual control (Manual) or testing (Test).
Accesses pan and tilt options for focus swap function, movement enable/disable,
manual control and testing.
Indicates that a test has passed.
Accesses options to turn lamp on or off.
Accesses options for lamp power up state.
Currently programming the new version of software.
Recalibrates luminaire.
Resets default system configuration values.
Resets lamp hour and strike counters. (For use when new lamp is installed.)
Specifies gobo wheel 2 (fixed gobo wheel) for manual control (Manual) and testing
(Test)
Specifies shutter mechanism rotating function for manual control (Manual) and test-
ing (Test)
Indicates that a mechanism test is in progress.
Accesses sensor types for diagnostic testing.
Accesses unit model type options (do not change).
Allows scrolling through error list or displays OK if no errors.
Specifies strobe function for manual control (Manual) or testing (Test).
Indicates that a system sensor test is in progress.
Swaps pan/tilt action for special focus requirements.
Test Accesses diagnostic tests for internal mechanisms.
Tilt Specifies tilt function for manual control (Manual) or testing (Test).
Displays current software version date and time (in two pages).
Specifies zoom function for manual control (Manual) or testing (Test).
M
ENU
31-July-2004
S : M F
YSTEM ENU UNCTIONS
4
53