Installing in Truss:
Step 1. Using two people, lift luminaire into mounting position.
Step 2. Secure in place with truss hook. Ensure truss hook hardware that locks hook in place (e.g.
wing bolt) is properly tightened and that luminaire is fully supported.
Step 3. Attach safety cable (as required) as follows:
a. Connect one end of cable to luminaire handle.
b. Loop at least once around truss/pipe and attach other end of cable to other handle.
Step 4. Connect power and data cables according to procedure given in
Power" on page
Safety Cable:
Recommended for all hanging installations
and may be required by local codes.
5"
(127 mm)
31.57"
(802 mm)
26.56"
(675 mm)
02.9 678.00 19 0
14.
18"
(457 mm)
20"
(508 mm)
Figure 2-4: Hanging Configuration and Dimensions
31-July-2004
I
: I
NSTALLATION
NSTALLATION
14.5"
(368 mm)
Handles are approved
safety cable anchor points.
26"
(660 mm)
24"
(610 mm)
P
ROCEDURES
"Connecting Data and
Top View
Safety Cable
(not included)
Loop at
least once
2
13