Vari Lite VL3500 Luminaire series Handbuch Seite 36

VARI LITE® - VL3500™ S
To use control channel functions:
Step 1. Select an action to be sent*.
Step 2. Set control channel value for desired action (for example, 84 for reset). Hold value for 3
seconds.
Step 3. Set control channel value to zero. (This must occur without any scaling values. Action will
be voided if other values are detected between action value and zero.)
Note: A numerical keypad is required for sending values. An encoder or fader does not allow for a
quick value change, which is required to effect the control functions.
* = Only this step is required for Pan/Tilt mode.
20
L U
ERIES UMINAIRE SER
31-July-2004
' M
S ANUAL
0 2.9678 .0019 0