Service; Fig.9 Data Plate - Igloo Rafal B Bedienungsanleitung

This concerns the "IGLOO" thermostat) The device is working, sound signalling is activated...- Make sure that:
• The condenser is clean, if necessary – clean the condenser
• Condenser ventilator is working properly
• Ambient temperature does not exceed 25ºC
The device is working too loud...– Make sure that:
• The device is standing stably and is properly levelled
• Furniture adjoining the device do not vibrate when the compressor is working
Noises made by the operating device are a normal phenomenon. The devices are equipped with venti-
lators, engines and compressors, which turn on and off automatically Each compressor makes certain
noises when operating. These sounds are made by the aggregate engine and by cooling agent
fl owing through the circuit. This phenomenon constitutes a technical feature of cooling devices
and it does not signify their faulty work.
Steam precipitation on glasses of the device is a normal phenomenon in case of high relative air
humidity exceeding 60% and does not require calling the service!

6.2. SERVICE

If after checking points described in chapter 6.1 „Fault identifi cation and repair" the device still does not work properly, please
contact Technical Service of the Igloo company, stating the data from the data plate Fig.9 (p.16):

Fig.9 Data plate

16
User manual RAFAŁ B
• Serial number (NS)
• Production date
• Type (name of the device)
and
• Date when the device was purchased
• Description of the problem
• Your exact address and telephone number (with the code number)
The above fi gure shows a demonstrative data plate
and the data stated on the plate are exemplary data,
which are not related with "RAFAŁ B" device!
en
www.igloo.pl