SUPREME SOFT Montageanleitung Seite 12

MAINTENANCE
[3]
OUT
2
MAINTENANCE POSITION [3]
1. inlet valve to appliance is OPEN.
2. outlet valve from appliance is CLOSED.
WITH 3-VALVE BYPASS SYSTEM (not included)
[1]
3
SERVICE POSITION [1]
1. bypass valve is CLOSED.
2. inlet valve to appliance is OPEN.
3. outlet valve from appliance is OPEN.
[2]
3
BYPASS POSITION [2]
1. bypass valve is OPEN.
2. inlet valve to appliance is CLOSED.
12
3. outlet valve from appliance is CLOSED.
IN
1
1
2
1
2
[3]
1
3
MAINTENANCE POSITION [3]
1. bypass valve is OPEN.
2. inlet valve to appliance is OPEN.
3. outlet valve from appliance is CLOSED.
WATER CONDITIONER SALT
The appliance needs 'brine' for its periodic regenerations.
This brine solution is made from water, that
is automatically dosed in the brine cabinet by the control
valve, and water conditioner salt. The user should make
sure that the brine cabinet is always kept full of water
conditioner salt. Therefore he should periodically check
the salt level inside the brine cabinet and refill
it if necessary. The salt lid can be removed completely
to facilitate refilling.
Ideally the level of water conditioner salt inside the brine
cabinet is kept between 1/3 and 2/3. A lower level of water
conditioner salt can cause insufficient brine saturation,
resulting in a loss of softening capacity. A higher level
of water conditioner salt can cause salt bridging (hard
crust or salt bridges in the brine cabinet). When you
suspect salt bridging:
- carefully pound on the outside of the brine cabinet
to break loose the salt bridges;
- using a broom (or like blunt tool) carefully push
the salt to break it apart;
- pour warm water over the top of the salt to dissolve it.
APPEARANCE
To retain the appearance of the appliance, simply wipe
it with a damp cloth or clean it with a mild soap solution;
never use abrasive cleaners, ammonia or solvents.
2