Powering Up/Down - RIDGID SeekTech ST-510 Bedienungsanleitung

SeekTech
Tools For The Professional
TM
Optional External Power Source
Use only a power supply approved to IEC 61010-1 or IEC
60950. Output must be isolated, SELV and Limited-Energy
Circuit per IEC 61010-1 or LPS per IEC 60950, 12-15VDC, 30W
minimum. Output connection is standard barrel plug, 2.1mm
pin, tip positive.
DANGER! If the line transmitter is powered by a
vehicle 12 VDC cigarette lighter connection, and the line
transmitter is connected to a power line, the vehicle is
now connected to that power line. The vehicle is now at a
potentially lethal voltage. If the vehicle is grounded, the
line transmitter may be destroyed.

Powering Up/Down

Power the unit ON/OFF by depressing the Power
the keypad.
Sounds of the SeekTech Transmitter
Sounds are associated with specific events.
The unit will beep, then pause to measure how much current
is flowing onto the cable or pipe. The unit will beep faster
when more current is detected.
To mute the sound, press the Sound key.

ST-510
®
key on
Ridge Tool Company
Using the ST-510 Line Transmitter
The ST-510 line transmitter can apply an active tracing signal
to a target conductor in three ways:
Figure 5
Figure 6
Figure 7