Useful Information - RIDGID SeekTech ST-510 Bedienungsanleitung

SeekTech
Tools For The Professional
TM

Useful Information

Using High and Low Frequencies
High Frequencies:
• Don't travel as far
• Overcome some barriers
• Bleed-over more.
Low Frequencies:
• Travel further
• Lose signal when hitting barriers, gaskets, poor
insulation
• Do not bleed-over as much.
As a general rule, detecting with lower frequencies is more
reliable for the reasons given above, IF you can get a good
signal.
FCC Limits
47 CFR 15.213 says that from 9 kHz up to (but not including)
45 kHz, peak output power shall not exceed 10 W. From
45 kHz to 490 kHz, it must not exceed 1 W.
Transportation and Storage
Before transporting make sure that the unit is OFF to preserve
battery power.
Make sure that the ST-510 line transmitter is secure and does
not bounce around or get bumped by loose equipment.
The ST-510 line transmitter should be stored in a cool dry
place.
NOTE: If storing the ST-510 line transmitter for an extended
period of time, the batteries should be removed. If storage
is brief then the battery carriage may be pulled out ½ an
inch to preserve battery power. Remove batteries entirely
before shipping.

ST-510
®
Ridge Tool Company
Maintenance and Cleaning
1. Keep the ST-510 line transmitter clean with a damp
cloth and some mild detergent. Do not immerse in
water.
2. When cleaning, do not use scraping tools or abrasives
as they may permanently scratch the display. NEVER
USE SOLVENTS to clean any part of the system.
Substances like acetone and other harsh chemicals
can cause cracking of the case. Locating Faulty
Components.
For troubleshooting suggestions, please refer to the trouble
shooting guide at the end of the manual.
Service and Repair
The unit should be taken to a RIDGID Independent
Authorized Service Center. All repairs made by Ridge service
facilities are warranted against defects in material and
workmanship.
If you have any questions regarding the service or repair of
this machine, contact your RIDGID distributor, local RIDGID
office or Ridge Tool Europe at info.europe@ridgid.com.
CAUTION: Always remove batteries entirely before
shipping.