Pulling The Load - Nordforest JM-3200 Bedienungsanleitung

Document number | 09.2017
›
Insert the round sling into the anchor hole between the two housing
plates.
›
Slide the anchor pin through the anchor hole and the round sling.
›
Turn the anchor pin twice to secure it.
›
Secure the anchor pin with the locking cotter pin.

Pulling the load

Danger due to slipping load!
Serious injuries are possible.
›
Never actuate the T-handle when the load is being pulled.
If the cable winch is overloaded, the shear pin breaks.
i
Observe the cable winch's performance limits (see "Technical
specifications" on page 51).
›
Anchor the load with the SIKA hook on the end of the rope.
›
Place the supplied lever pipe on the required lever.
›
Move the "Forward gear" lever to pull the load forwards.
›
Move the "Reverse gear" lever to pull the load backwards.
›
To stop working, no longer pull the levers. The load stops
in its position.
Nordforest 800, 1600 and 3200 kg cable winch
Operating the cable winch
WARNING
45