Fm Radio Mode - auna MC-30 DAB Handbuch

FM RADIO MODE

Check that your Micro System is in FM radio mode. If you are not already
in FM mode, briefly press and release the Mode button on the front of the
Micro System or on the remote control, until you are in FM mode (check the
display). When your Micro System is in FM mode it can receive Radio Data
System or 'RDS' information if this is being transmitted by the broadcaster.
RDS information will often include the station name, detail about the
programme and the current time.
If you were listening to an FM station when you switched the Micro System
off then this station will be automatically selected when you switch the
Micro System back on.
Wire radio aerial
Please make sure that the wire aerial on the back of the Micro System is
fully extended and adjusted before you attempt to tune to an FM radio
station (a vertical position is recommended). This will ensure that the
maximum signal strength is available when the Micro System begins to
scan. Extending the aerial also ensures the best possible sound quality.
Tuning to an FM station
In FM mode:
1. Press and release the Play/Pause button on the Micro System or the
Scan button on the remote control to scan up the frequency band. Press
and hold the Play/Pause button on the Micro System or the Scan button
on the remote control to scan down the frequency band. Your Micro
System will search for the next available station and then stop on that
station.
2. Press and release the Tune+ or Tune- on the front of the Micro System
or the Previous/Next buttons on the remote control to fine tune each
frequency in 0.05 MHz steps, if necessary.
EN
39