Push Buttons - Phocos CIS-CU Bedienungsanleitung

How to use CIS-CU
Configuring your CIS using the CIS-CU is very easy.
Set all switches to desired settings ---> Press "Send" button ---> Wait
for response.
Buzzer Response
After transmitting
After transmitting
After pressing test button
After pressing button
LED Response
"Error" after "Transmit"
"Error" while "Transmit"
"Error"
"OK" after "Transmit"
"Transmit"

Push Buttons

Test
Send
1) If pressing the button causes a load disconnect event (LVD/SOC, over
current) the load will be switched off.
2) This action will send all the settings to the CIS controller. Be sure to
program only one CIS at a time.
Programming error
Programming successful
Test command transmitted
CIS-CU battery empty
Programing error
Low battery
Battery empty
Programming successful
Transmitting
Load(s) on for 2 minutes
Transmit all settings
19
1
2